Plasma cutting machine manufacturers_CNC plasma cutting machineIn the daily production process will lead to a large amount of dust, so it is necessary to install a strong ventilation device in the equipment workplaceCNC plasma cutting machineThe fumes generated during the cutting process are discharged. Before powering on the equipment, check that all switches on the equipment are in the off position and that the rotary switch at the rear of the plasma power supply is in the horizontal position.

Plasma cutting machine manufacturers_CNC plasma cutting machineThe preparation of the work is introduced:

11. Connect the power supply of the main switch cabinet to make the two cables have power;

22. Switch the circuit breaker in the equipment electrical cabinetHAS ADOPTED THIS REGULATION:Location;

3Turn on the system control power with the key switch, and the main interface of the display shall appear;

4Turn the rotary switch at the rear of the plasma power supply90° to vertical position. At this time, the power indicator at the front of the plasma power supply should be on;

5, Turn on the air compressor, adjust the air compressor pressure control switch, so that the output air pressure of the compressor is6.1-8.2Bar;

6Adjust the air pressure adjustment knob on the plasma power supply to keep the pressure5.5-6.0Bar;

7Current regulation of rotating plasma power supply/Turn the gas test knob to the gas test position to confirm that the gas pressure will not drop below5BarWhen the pressure is lower5Barwill seriously affect the cutting quality, and even make the plasma power supply to stop working.

IfCNC plasma cutting machineThe working environment can not guarantee the supply of air source clean, should be installed in front of the plasma power supply multi-stage combined filtration system, otherwise the air containing oil, moisture, dust, in the cutting will cause arc failure, torch damage and other serious consequences. WhenCNC plasma cutting machineAfter the start-up preparation has been completed, the plates to be cut can be placed in the appropriate position of the workbench. The plates cannot touch the track. The program shall be compiled according to the drawings or software. If necessary, empty car cutting shall be made to check whether the programming is accurate.CNC plasma cutting machineWhen cutting, the equipment should be started first, the entry point should be found, the cutting parameters should be adjusted, the air source should be turned on, the plasma cutting machine should be started, and the program control cutting should be entered. It is strictly forbidden to stand on the cut plate and rack track, and do not mess with electrical components and transmission components; keep the transmission rack, guide rail, transmission steel belt and control console clean and maintained to ensure the operation accuracy.